User Tools

Site Tools



en:bpi-r2:lede

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
en:bpi-r2:lede [2018/01/16 17:31]
frank [EMMC]
en:bpi-r2:lede [2020/08/29 17:14] (current)
Line 27: Line 27:
 img-files are on my [[https://drive.google.com/drive/folders/1oP7jy1KrrIOifvImo2nQ59wx3_9hHkgk?usp=sharing|gdrive]] img-files are on my [[https://drive.google.com/drive/folders/1oP7jy1KrrIOifvImo2nQ59wx3_9hHkgk?usp=sharing|gdrive]]
  
 +Please note that lede currently not support hdmi-output (you will see only a purple screen).
 ===== SD ===== ===== SD =====
  
Line 39: Line 40:
   - Unlock EMMC boot0 block: echo 0 > /sys/block/mmcblkXboot0/force_ro   - Unlock EMMC boot0 block: echo 0 > /sys/block/mmcblkXboot0/force_ro
   - flash preloader to EMMC boot0 block: dd if=mtk-bpi-r2-EMMC.img of=/dev/mmcblkXboot0 bs=1M count=1   - flash preloader to EMMC boot0 block: dd if=mtk-bpi-r2-EMMC.img of=/dev/mmcblkXboot0 bs=1M count=1
-  - Change the Partition configurion of EMMC to 48h: reboot the system which is running  from SD, and enter the U-boot-console, run command "emmc pconf 48"+  - Change the Partition configurion of EMMC to 48h: reboot the system which is running  from SD, and enter the [[uboot|U-boot-console]], run command "emmc pconf 48"
   - Power off, remove SD card, and then power on R2 board.   - Power off, remove SD card, and then power on R2 board.
 +
 +
 +===== Network-configuration =====
 +
 +By default lan-ports are bridged together with IP-address 192.168.1.1
 +
 +Further configuration see here:
 +https://wiki.openwrt.org/doc/uci/network
en/bpi-r2/lede.1516120315.txt.gz · Last modified: 2020/08/29 17:14 (external edit)