Differences

This shows you the differences between two versions of the page.

--- en:bpi-r4:start [2024/04/21 13:25] – [GPIO] frank
+++ en:bpi-r4:start [2024/04/28 11:48] – [rtc] frank
@@ Line 31: / Line 31: @@
 {{:en:bpi-r4:bpi-r4_v1.1_top.jpg?direct&400 |}} {{ :en:bpi-r4:bpi-r4_v1.1_bottom.jpg?direct&400|}}
 ===== thermal =====
+  cat /sys/class/thermal/thermal_zone0/temp
 Uses lvts driver
@@ Line 144: / Line 149: @@
 root@bpi-r4-v11:~
 # echo 1 > /sys/devices/platform/gpio-leds/leds/green:status/brightness
+root@bpi-r4-v11:~
+</code>
+===== rtc =====
+Battery connection looks like charging circuit for ml2032. You should not connect non-rechargeable battery like cr2032.
+https://forum.banana-pi.org/t/bpi-r3-bpi-r4-does-the-bpi-r3-r4-have-a-rtc/17763/36
+Connector is JST with 1.25mm pitch
+RTC time will survive software reboot
+<code>
+# dmesg | grep rtc
+[    1.479923] rtc-pcf8563 2-0051: low voltage detected, date/time is not reliable.
+[    1.487390] rtc-pcf8563 2-0051: registered as rtc0
+[    1.493378] rtc-pcf8563 2-0051: low voltage detected, date/time is not reliable.
+[    1.500771] rtc-pcf8563 2-0051: hctosys: unable to read the hardware clock
+root@bpi-r4-v11:~
+# date -s "2024-04-27 09:55 CEST"
+Sat Apr 27 07:55:00 UTC 2024
+root@bpi-r4-v11:~
+# hwclock -w
+root@bpi-r4-v11:~
+# hwclock -r
+-04-27 07:56:23.979830+00:00
+root@bpi-r4-v11:~
+# reboot
+...
+root@bpi-r4-v11:~
+# dmesg | grep rtc
+[    1.480067] rtc-pcf8563 2-0051: registered as rtc0
+[    1.486061] rtc-pcf8563 2-0051: setting system clock to 2024-04-27T07:56:53 )
+root@bpi-r4-v11:~
+# date
+Sat Apr 27 08:00:46 UTC 2024
 root@bpi-r4-v11:~
 </code>
@@ Line 151: / Line 192: @@
 currently use these:
-  * uboot: https://github.com/frank-w/u-boot/tree/2023-10-bpi
+  * uboot: https://github.com/frank-w/u-boot/tree/2024-04-bpi
   * ATF: https://github.com/frank-w/u-boot/tree/mtk-atf